Dimentions: SVG >CNC

-----Mensagem original-----
De: <email address hidden> [mailto:<email address hidden>] Em nome de Alfredo M
Enviada: terça-feira, 16 de maio de 2017 14:58
Para: Alfredo José Almeida Martins <email address hidden>
Assunto: [Question #632726]: Dimentions: SVG >CNC

New question #632726 on Inkscape:
https://answers.launchpad.net/inkscape/+question/632726

I'm starting to use Inkscape 0.92.1 r15371 When passing a figure from svg to cnc code the dimensions are reduced about 2.5 times.
What do I do wrong? I can send files

--
You received this question notification because you asked the question.

What method are you using to generate the gcode?

Can you link to an svg file and the resulting gcode file?

-----Mensagem original-----
De: <email address hidden> [mailto:<email address hidden>] Em nome de TylerDurden
Enviada: terça-feira, 16 de maio de 2017 16:28
Para: Alfredo José Almeida Martins <email address hidden>
Assunto: Re: [Question #632726]: Dimentions: SVG >CNC

Your question #632726 on Inkscape changed:
https://answers.launchpad.net/inkscape/+question/632726

    Status: Open => Needs information

TylerDurden requested more information:
What method are you using to generate the gcode?

Can you link to an svg file and the resulting gcode file?

--
To answer this request for more information, you can either reply to this email or enter your reply at the following page:
https://answers.launchpad.net/inkscape/+question/632726

You received this question notification because you asked the question.

hello, when i use my cnc, i save as a dxf file, then use sheetcam to convert to g code. i also save an svg file so i can go back and edit later, but the dxf file is what sheetcam uses. also i have a vinyl plotter. when i use that i save as an eps file. i'd give those a try and see if it works. hope this helps you