HPLIP command syntax

Try running 'xsane'. It will most likely be in your system menu under
"Graphics" or similar title. If not, use your system tools to install it.

On Fri, Apr 17, 2009 at 4:22 AM, Paul
<email address hidden>wrote:

> New question #67742 on HPLIP:
> https://answers.launchpad.net/hplip/+question/67742
>
> I have LINUX Mint 6, I use a HP 1215 PSC which is fine in printing mode but
> I couldn't get it to scan.
> I have installed the HP device Manager HPLIP 2.8.7 and find in the
> configure panel: F2, under Scan, the command line is empty
> Does anyone know the command line and syntax to start the scanner?
> If I use terminal, command: hp-scan -n I get a dialogue with a request for
> which device, and the HPLIP panel sees the scan start and end fine, so how
> can I do this from the HPLIP panel.
>
> If this is a bit vague I apologise, I have only been using Linux for 4
> weeks, I was M$ for over 20 yrs until Vesta(!)
>
> --
> You received this question notification because you are a member of HP
> Linux Imaging and Printing, which is an answer contact for HPLIP.
>