focal/linux-raspi: Upstream raspberrypi patchset 2020-06-10

Bug #1882930 reported by Juerg Haefliger
6
This bug affects 1 person
Affects Status Importance Assigned to Milestone
linux-raspi (Ubuntu)
Fix Released
Undecided
Unassigned
Focal
Fix Released
Medium
Unassigned

Bug Description

Upstream raspberrypi patchset 2020-06-10

   Ported from the following raspberrypi branch:
      rpi-5.4.y

from https://github.com/raspberrypi/linux.git

w1_therm: remove redundant assignments to variable ret
w1_therm: Free the correct variable
w1_therm: adding bulk read support to trigger multiple conversion on bus
w1_therm: adding alarm sysfs entry
w1_therm: optimizing temperature read timings
w1_therm: adding eeprom sysfs entry
w1_therm: adding resolution sysfs entry
w1_therm: adding ext_power sysfs entry
w1_therm: fix reset_select_slave during discovery
w1_therm: adding code comments and code reordering
overlays: Update upstream overlays after vc4-kms-v3d change
overlays: i2c-gpio: Avoid open-drain warnings
Revert "overlays: gpio-keys: Avoid open-drain warnings"
snd_bcm2835: disable HDMI audio when vc4 is used (#3640)
vc4: cec: Restore cec physical address on reconnect
staging: vchiq_arm: Use g_dma_dev for dma_unmap_sg
vc4: Set driver_name for card
configs: Add SND_SOC_MAX98357A=m
Add Micro Crystal RV-1805 to i2c-rtc overlays
media: bcm2835-isp: fix bytes per line calculations for some image formats
overlays: i2c-rtc-gpio: Fix trickle-resistor-ohms param
net: rtl8192cu: fix gcc misleading whitespace warning
overlays: Add spi0 overlay to support sc16is752
overlays: gpio-shutdown: Add information for Raspberry Pi 1 Model B rev 1
overlays: gpio-shutdown: Add information for SysV init / inittab
overlays: i2c-rtc: Fix trickle-resistor-ohms param
brcmfmac: BCM43436 needs dedicated firmware
configs: Build HWMON core into kernel
configs: Switch to upstream thermal sensor for RPi 4 - BCM2711_THERMAL
ARM: dts: bcm2711-rpi: Remove downstream thermal sensor node
Revert "thermal: brcmstb_thermal: Add BCM2838 support"
Revert "thermal: brcmstb_thermal: Correct SoC name"
ARM: configs: Build BCM2711 thermal as module
ARM: dts: bcm2711: Enable thermal
thermal: Add BCM2711 thermal driver
dt-bindings: Add Broadcom AVS RO thermal
media: bcm2835-unicam: change minimum number of vb2_queue buffers to 1
ARM: dts: Update for new VCHIQ BCM2711 DMA support
staging: vchiq_arm: Clean up 40-bit DMA support
media: i2c: imx477: Return correct result on sensor id verification
drm/vc4: Add FKMS as an acceptable node for dma ranges.
drm/vc4: Adopt the dma configuration from the HVS or V3D component
configs: Add ZSWAP=y, ZBUD=m, Z3FOLD=m
zswap: Defer zswap initialisation
media: bcm2835-unicam: Retain packing information on G_FMT
Switch to snd_soc_dai_set_bclk_ratio
overlays: Fix audio parameter of vc4-kms-v3d
configs: Restore missing NF_TABLES settings
staging:vc04_services: bcm2835-camera: Request headers with I-frame
staging:vc04_services: bcm2835-codec: Avoid fragmenting buffers
staging:vc04_services: bcm2835-codec: Request headers with I-frame
staging: vc04_services: mmal-vchiq: Update parameters list
drm/vc4: Fix VIC usage with Broadcast RGB
sc16is7xx: Fix for hardware flow control
media: bcm2835-unicam: Always service interrupts
configs: Use the upstream cpufreq driver
configs: Include the firmware-clocks driver
ARM: dts: Enable firmware-clocks on all Pis
defconfig: Add CMA and system dma-heaps to the config
dma-heap: Make the symbol 'dma_heap_ioctl_cmds' static
dma-buf: fix resource leak on -ENOTTY error return path
dma-buf: heaps: Remove redundant heap identifier from system heap name
dma-buf: heaps: Use _IOCTL_ for userspace IOCTL identifier
kselftests: Add dma-heap test
dma-buf: heaps: Add CMA heap to dmabuf heaps
dma-buf: heaps: Add system heap to dmabuf heaps
dma-buf: heaps: Add heap helpers
dma-buf: Add dma-buf heaps framework
udmabuf: fix dma-buf cpu access
udmabuf: implement begin_cpu_access/end_cpu_access hooks
udmabuf: separate out creating/destroying scatter-table
udmabuf: add a pointer to the miscdevice in dma-buf private data
udmabuf: use cache_sgt_mapping option
udmabuf: Remove deleted map/unmap handlers.
configs: Add imx477 sensor driver to all Raspberry Pi defconfigs
media: i2c: imx477: Add support for adaptive frame control
media: i2c: Add driver for Sony IMX477 sensor
dtoverlays: Add IMX477 sensor overlay
dt-bindings: media: i2c: Add IMX477 CMOS sensor binding
raspberrypi: dts: Switch to discrete ALSA devices
overlays: Move "fixed-clock" nodes to the root
overlays: tc358743: Use intra-overlay fragments
bcm2835-dma: Add proper 40-bit DMA support
clk-raspberrypi: Allow cpufreq driver to also adjust gpu clocks
drm/vc4: Fix HDMI mode validation
gpiolib: Don't prevent IRQ usage of output GPIOs

Juerg Haefliger (juergh)
Changed in linux-raspi (Ubuntu):
status: New → Confirmed
Juerg Haefliger (juergh)
Changed in linux-raspi (Ubuntu):
status: Confirmed → New
status: New → Confirmed
Changed in linux-raspi (Ubuntu Focal):
status: New → Confirmed
Juerg Haefliger (juergh)
no longer affects: linux-raspi (Ubuntu Focal)
Juerg Haefliger (juergh)
description: updated
Stefan Bader (smb)
Changed in linux-raspi (Ubuntu Focal):
importance: Undecided → Medium
status: New → In Progress
Juerg Haefliger (juergh)
Changed in linux-raspi (Ubuntu):
status: Confirmed → Invalid
Juerg Haefliger (juergh)
description: updated
description: updated
Changed in linux-raspi (Ubuntu Focal):
status: In Progress → Fix Committed
Revision history for this message
Launchpad Janitor (janitor) wrote :
Download full text (37.2 KiB)

This bug was fixed in the package linux-raspi - 5.4.0-1015.15

---------------
linux-raspi (5.4.0-1015.15) focal; urgency=medium

  * focal/linux-raspi: 5.4.0-1015.15 -proposed tracker (LP: #1887056)

  [ Ubuntu: 5.4.0-42.46 ]

  * focal/linux: 5.4.0-42.46 -proposed tracker (LP: #1887069)
  * linux 4.15.0-109-generic network DoS regression vs -108 (LP: #1886668)
    - SAUCE: Revert "netprio_cgroup: Fix unlimited memory leak of v2 cgroups"

linux-raspi (5.4.0-1014.14) focal; urgency=medium

  * focal/linux-raspi: 5.4.0-1014.14 -proposed tracker (LP: #1885841)

  * Add crda dependency (LP: #1877415)
    - [Packaging] raspi: Depend on crda

  * dtoverlay=uart4 breaks Raspberry Pi 4B boot (LP: #1875454)
    - SAUCE: arm: dts: Add 'brcm, bcm2835-pl011' for compatible for uart2-5

  * aarch64 kernel module for exfat not in raspberry pi 4 build (LP: #1880503)
    - [Config] raspi: Set EXFAT_FS=m

  * Enable ZFS for Raspberry Pi arm64 (LP: #1884110)
    - [Config] raspi: Enable zfs modules for arm64

  * focal/linux-raspi: Upstream raspberrypi patchset 2020-06-10 (LP: #1882930)
    - Revert "net: bcmgenet: Workaround for Pi 4B network issue"
    - Revert "gpiolib: Don't prevent IRQ usage of output GPIOs"
    - gpiolib: Don't prevent IRQ usage of output GPIOs
    - drm/vc4: Fix HDMI mode validation
    - clk-raspberrypi: Allow cpufreq driver to also adjust gpu clocks
    - bcm2835-dma: Add proper 40-bit DMA support
    - overlays: tc358743: Use intra-overlay fragments
    - overlays: Move "fixed-clock" nodes to the root
    - raspberrypi: dts: Switch to discrete ALSA devices
    - dt-bindings: media: i2c: Add IMX477 CMOS sensor binding
    - dtoverlays: Add IMX477 sensor overlay
    - media: i2c: Add driver for Sony IMX477 sensor
    - media: i2c: imx477: Add support for adaptive frame control
    - configs: Add imx477 sensor driver to all Raspberry Pi defconfigs
    - udmabuf: Remove deleted map/unmap handlers.
    - udmabuf: use cache_sgt_mapping option
    - udmabuf: add a pointer to the miscdevice in dma-buf private data
    - udmabuf: separate out creating/destroying scatter-table
    - udmabuf: implement begin_cpu_access/end_cpu_access hooks
    - udmabuf: fix dma-buf cpu access
    - dma-buf: Add dma-buf heaps framework
    - dma-buf: heaps: Add heap helpers
    - dma-buf: heaps: Add system heap to dmabuf heaps
    - dma-buf: heaps: Add CMA heap to dmabuf heaps
    - kselftests: Add dma-heap test
    - dma-buf: heaps: Use _IOCTL_ for userspace IOCTL identifier
    - dma-buf: heaps: Remove redundant heap identifier from system heap name
    - dma-buf: fix resource leak on -ENOTTY error return path
    - dma-heap: Make the symbol 'dma_heap_ioctl_cmds' static
    - defconfig: Add CMA and system dma-heaps to the config
    - ARM: dts: Enable firmware-clocks on all Pis
    - configs: Include the firmware-clocks driver
    - configs: Use the upstream cpufreq driver
    - media: bcm2835-unicam: Always service interrupts
    - sc16is7xx: Fix for hardware flow control
    - drm/vc4: Fix VIC usage with Broadcast RGB
    - staging: vc04_services: mmal-vchiq: Update parameters list
    - staging:vc04_services: bcm2835-codec: Request headers with I-frame
  ...

Changed in linux-raspi (Ubuntu Focal):
status: Fix Committed → Fix Released
Changed in linux-raspi (Ubuntu):
status: Invalid → Fix Released
To post a comment you must log in.
This report contains Public information  
Everyone can see this information.

Other bug subscribers

Remote bug watches

Bug watches keep track of this bug in other bug trackers.