Ubuntu
linux package

  1. Bug #594866
  2. Comment #32

Comment 32 for bug 594866

Revision history for this message
Simão (simao) wrote :

I have the same problem.

[ 10.934914] rt2800pci 0000:04:06.0: PCI INT A -> GSI 21 (level, low) -> IRQ 21
[ 11.035987] phy0: Selected rate control algorithm 'minstrel'
[ 11.036475] Registered led device: rt2800pci-phy0::radio
[ 11.036488] Registered led device: rt2800pci-phy0::assoc
[ 11.036501] Registered led device: rt2800pci-phy0::quality

[ 11.932183] phy0 -> rt2800pci_mcu_status: Error - MCU request failed, no response from hardware
[ 11.990860] ADDRCONF(NETDEV_UP): wlan0: link is not ready

My card is d-link dwa 525 and has ralink RT2860 chip.

lspci -vv

04:06.0 Network controller: RaLink Device 3060
 Subsystem: D-Link System Inc Device 3c04
 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
 Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
 Latency: 32 (500ns min, 1000ns max), Cache Line Size: 64 bytes
 Interrupt: pin A routed to IRQ 21
 Region 0: Memory at fb100000 (32-bit, non-prefetchable) [size=64K]
 Capabilities: [40] Power Management version 3
  Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
  Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
 Kernel driver in use: rt2800pci
 Kernel modules: rt2800pci