Ethtool information for the NIC in my T110ii, which has so far *not* given me any problems:
Settings for eth0: Supported ports: [ TP ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Supported pause frame use: No Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Advertised pause frame use: Symmetric Advertised auto-negotiation: Yes Speed: 1000Mb/s Duplex: Full Port: Twisted Pair PHYAD: 1 Transceiver: internal Auto-negotiation: on MDI-X: Unknown Supports Wake-on: g Wake-on: d Current message level: 0x000000ff (255) drv probe link timer ifdown ifup rx_err tx_err Link detected: yes
driver: tg3 version: 3.121 firmware-version: 7.2.14 bc 5722-v3.11 bus-info: 0000:02:00.0 supports-statistics: yes supports-test: yes supports-eeprom-access: yes supports-register-dump: yes
Ethtool information for the NIC in my T110ii, which has so far *not* given me any problems:
Settings for eth0:
100baseT/ Half 100baseT/Full
1000baseT/ Half 1000baseT/Full
100baseT/ Half 100baseT/Full
1000baseT/ Half 1000baseT/Full
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
Advertised pause frame use: Symmetric
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
MDI-X: Unknown
Supports Wake-on: g
Wake-on: d
Current message level: 0x000000ff (255)
drv probe link timer ifdown ifup rx_err tx_err
Link detected: yes
driver: tg3 statistics: yes eeprom- access: yes register- dump: yes
version: 3.121
firmware-version: 7.2.14 bc 5722-v3.11
bus-info: 0000:02:00.0
supports-
supports-test: yes
supports-
supports-