nic not recognized on hp laptop

can you give the output of:

sudo lshw -C network; sudo iwlist scan

Thanks

 *-network DISABLED
       description: Ethernet interface
       product: MCP67 Ethernet
       vendor: nVidia Corporation
       physical id: a
       bus info: pci@0000:00:0a.0
       logical name: eth102
       version: a2
       serial: 00:00:6c:e7:f0:ef
       size: 100MB/s
       capacity: 100MB/s
       width: 32 bits
       clock: 66MHz
       capabilities: pm msi ht bus_master cap_list ethernet physical mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
       configuration: autonegotiation=on broadcast=yes driver=forcedeth driverversion=0.64 duplex=full latency=0 link=yes maxlatency=20 mingnt=1 multicast=yes port=MII speed=100MB/s
       resources: irq:20 memory:f2588000-f2588fff ioport:30f8(size=8) memory:f2589c00-f2589cff memory:f2589800-f258980f
  *-network
       description: Wireless interface
       product: BCM4328 802.11a/b/g/n
       vendor: Broadcom Corporation
       physical id: 0
       bus info: pci@0000:03:00.0
       logical name: eth5
       version: 03
       serial: 00:1a:73:ed:39:79
       width: 64 bits
       clock: 33MHz
       capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless
       configuration: broadcast=yes driver=wl0 driverversion=5.10.91.9 ip=192.168.0.199 latency=0 multicast=yes wireless=IEEE 802.11abgn
       resources: irq:19 memory:f2200000-f2203fff memory:f2000000-f20fffff(prefetchable)
  *-network DISABLED
       description: Ethernet interface
       physical id: 1
       logical name: vboxnet0
       serial: 0a:00:27:00:00:00
       capabilities: ethernet physical
       configuration: broadcast=yes multicast=yes
mike@mike-laptop:~$
mike@mike-laptop:~$ sudo iwlist scan
lo Interface doesn't support scanning.

eth102 Interface doesn't support scanning.

eth5 Scan completed :
          Cell 01 - Address: 00:24:01:33:E5:5B
                    ESSID:"mjg3"
                    Mode:Managed
                    Frequency=2.422 GHz (Channel 3)
                    Quality:5/5 Signal level:-52 dBm Noise level:-91 dBm
                    IE: IEEE 802.11i/WPA2 Version 1
                        Group Cipher : TKIP
                        Pairwise Ciphers (2) : TKIP CCMP
                        Authentication Suites (1) : PSK

Ok and can you give the output of:

lspci

Thanks

mike@mike-laptop:~$ lspci
00:00.0 RAM memory: nVidia Corporation MCP67 Memory Controller (rev a2)
00:01.0 ISA bridge: nVidia Corporation MCP67 ISA Bridge (rev a2)
00:01.1 SMBus: nVidia Corporation MCP67 SMBus (rev a2)
00:01.2 RAM memory: nVidia Corporation MCP67 Memory Controller (rev a2)
00:01.3 Co-processor: nVidia Corporation MCP67 Co-processor (rev a2)
00:02.0 USB Controller: nVidia Corporation MCP67 OHCI USB 1.1 Controller (rev a2)
00:02.1 USB Controller: nVidia Corporation MCP67 EHCI USB 2.0 Controller (rev a2)
00:04.0 USB Controller: nVidia Corporation MCP67 OHCI USB 1.1 Controller (rev a2)
00:04.1 USB Controller: nVidia Corporation MCP67 EHCI USB 2.0 Controller (rev a2)
00:06.0 IDE interface: nVidia Corporation MCP67 IDE Controller (rev a1)
00:07.0 Audio device: nVidia Corporation MCP67 High Definition Audio (rev a1)
00:08.0 PCI bridge: nVidia Corporation MCP67 PCI Bridge (rev a2)
00:09.0 IDE interface: nVidia Corporation MCP67 AHCI Controller (rev a2)
00:0a.0 Ethernet controller: nVidia Corporation MCP67 Ethernet (rev a2)
00:0c.0 PCI bridge: nVidia Corporation MCP67 PCI Express Bridge (rev a2)
00:0d.0 PCI bridge: nVidia Corporation MCP67 PCI Express Bridge (rev a2)
00:12.0 VGA compatible controller: nVidia Corporation C67 [GeForce 7150M / nForce 630M] (rev a2)
00:18.0 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] HyperTransport Technology Configuration
00:18.1 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Address Map
00:18.2 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] DRAM Controller
00:18.3 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Miscellaneous Control
02:05.0 FireWire (IEEE 1394): Ricoh Co Ltd R5C832 IEEE 1394 Controller (rev 05)
02:05.1 SD Host controller: Ricoh Co Ltd R5C822 SD/SDIO/MMC/MS/MSPro Host Adapter (rev 22)
02:05.2 System peripheral: Ricoh Co Ltd R5C843 MMC Host Controller (rev 12)
02:05.3 System peripheral: Ricoh Co Ltd R5C592 Memory Stick Bus Host Adapter (rev 12)
02:05.4 System peripheral: Ricoh Co Ltd xD-Picture Card Controller (rev ff)
03:00.0 Network controller: Broadcom Corporation BCM4328 802.11a/b/g/n (rev 03)
mike@mike-laptop:~$

Thank you for the help nu2ubuntu.

The plot thickens, when I use the nm-applet for my wired connection it reads ifupdown eth13 connection, info from there says eth114. OK, thats interesting, when I use the "Devices Network-tools" it lists eth114 in the drop down menu but when I try to configure that device it says "Device interface does not exist-Check that it is correctly typed and that it is correctly supported by your system.". ifconfig lists that device but gives only a mac-addres. Link encap:Ethernet HWaddr 00:00:6c:57:3c:83
          inet6 addr: fe80::200:6cff:fe57:3c83/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:939 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B) TX bytes:94697 (94.6 KB)
          Interrupt:27 Base address:0x2000
Also, my wireless devices are no longer functioning. At present the only network connection I have is 3G. I have configured a wireless device in the Network settings dialog window but it is still no recognized. Are there any software packages that may have conflicts with each other or is there some thing I can remove and re-install? Any suggestions would be greatly appreciated, Thanks nu2ubuntu.

Thanks nafterburner, that solved my question.