Ubuntu
gnome-nettool package

Ubuntu 10.10 wireless on presario v2000

Asked by Ryan

Hello.....
i have had this problem on this laptop before but with Ubuntu 9.04 and i had it solved and this is the title the man who fixed it gave the problem....i have just changed the last part from in Ubuntu 9.04 to 10.10

Wireless Network controller [0280]: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller [14e4:4318] (rev 02) not working on Compaq Presario V2000 (EL088PA#ABG) in Ubuntu 10.10

I have installed Ubuntu 10.10 on my Compaq Presario v2000 today and the wireless does not work.
It says " device not ready (firmware not found) "

How can i fix this?????
any help would be much appreciated :3)
Thanks
Ryan

Question information

Language:
English Edit question
Status:
Answered
For:
Ubuntu gnome-nettool Edit question
Assignee:
No assignee Edit question
Last query:
Last reply:
Revision history for this message
Hsn (alshawaf) said : 		#1

connect your laptop using ethernet cable to the internet

than go to System --> Administration --> Additional Drivers

it should show you the drivers for your b43
chose it and click active

Revision history for this message
Mark Rijckenberg (markrijckenberg) said : 		#2

Hi,

Please first connect your network card to the wireless router using an ethernet cable (also known as a LAN cable).

In order to gather essential troubleshooting information about your wireless card, please follow this procedure:

Step 1: Open Terminal from "Applications->Accessories->Terminal"

Step 2: Please copy-paste the following command from the https://answers.launchpad.net/ubuntu website in Firefox into the Linux Terminal. Do NOT copy-paste from the Email message into the Terminal, as that will only copy PART of the command. The command STARTS with the word sudo and ENDS with the word lsmod. So please copy-paste the ENTIRE command below from Firefox into a Terminal, press <enter>, then enter password when sudo asks for password, then press enter again.

Tip: If you have a wheel mouse or 3 button mouse you do not need to type commands into the Terminal. Highlight the command written on the page. Move your cursor anywhere in the Terminal and press the wheel or middle button. Automatic Copy and paste! No spelling mistakes! No Typos! No other errors!

sudo apt-get update; sudo apt-get install hwinfo grep; sudo lshw -C network; rfkill list; sudo iwlist scanning; cat /etc/network/interfaces; cat /etc/lsb-release; lspci -nn; lsusb; sudo lshw -short; uname -a; dmesg | egrep 'acx|at76|ath|b43|bcm|CX|eth|ipw|irmware|isl|lbtf|orinoco|ndiswrapper|NPE|ound|p54|prism|rtl|rt2|rt3|rt6|rt7|usb|witch|wl'; iwconfig; cat /etc/modprobe.d/* | egrep 'acx|at76|ath|b43|bcm|CX|eth|ipw|irmware|isl|lbtf|orinoco|ndiswrapper|NPE|p54|prism|rtl|rt2|rt3|rt6|rt7|witch|wl'; sudo hwinfo --netcard ; cat /var/lib/NetworkManager/NetworkManager.state; sudo lsmod

Step 3: Please post results (copy/paste terminal output) on this thread. The troubleshooters here need to see the full Terminal output from running the above command.

Regards,

Mark

Can you help with this problem?

Provide an answer of your own, or ask Ryan for more information if necessary.

To post a message you must log in.